Search models, users, collections, and posts
1-to-5 USB Charger Board Casing
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
0
0
0
0
1
0
Released
Description
Content has been automatically translated.
DIY Electronics Practice - 8.8 Yuan 1-to-5 USB Charger Board Casing
Print directly with default parameters, using PETG in Ludicrous Mode for about 1 hour. There are two plates: one with a hole for the indicator light and one without. Light-colored filament generally does not require a hole; use the one with a hole for dark, opaque filament
A new wire clip has been added for motherboards without a figure-8 plug. The gray part in the middle of the image below is a negative part; the size of the hole can be manually adjusted according to the wire's thickness. Two small self-tapping screws are needed to secure the wire.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)