Valentine's Day Teddy Bear with and without AMS multipart

UPDATE 13.01.2026

after many asked for a multi-part version, I sat down and created the teddy again as a multi-part version, where the body - the nose & eyes - the heart & the pedestal can be printed separately

This way, you can also print it in multi-color WITHOUT AMS and then glue the parts together  I hope it meets the wishes of many I have added the pedestal 1x with a LOVE inscription and 1x WITHOUT a LOVE inscription so that you can individually label the pedestal or simply print it blank

I uploaded the profile last (multi-part version WITHOUT AMS)

Description

Valentine's Day - Teddy Bear

It's that time of year again, February 14th is Valentine's Day! 

The time to give a gift to your loved one ( of course, it shouldn't only be the case on this one day ;) )

But even outside of Valentine's Day, you can give this little teddy bear to people who are important to you

It was partly printed in a fine fuzzy look, to give the whole thing a special effect

I created the teddy bear in 5 color versions and uploaded them in separate profiles So there should be something for everyone

Whether with or without AMS, whether single-color or multi-color, partly colored, etc I have tried to cover everything

Otherwise, everyone is of course free to color the individual areas in the slicer as they wish :)

in addition, I have uploaded them in 0.2mm layer height and in 0.16mm layer height respectively, so that you can print it finer or faster as you like

Although I already find the 0.2 print very good But everyone is free to decide, I only offer it :)

here are the available models from left to right: 

• single color WITHOUT AMS
• two-color including pause at layer 87 for filament change WITHOUT AMS
• multi-color WITH AMS - Base White, Heart Red, Eyes Black
• multi-color WITH AMS - Base White, Heart Red, Eyes, Nose & Mouth Black
• multi-color WITH AMS - Base White, Heart Red
• divided for gluing - WITHOUT AMS (not shown in picture)

Print settings:

• Material: PLA (I used PLA Pearl White & PLA Wood)
• Nozzle: 0.4mm
• Layer height: 0.2mm & 0.16mm
• Infill: 10%
• Supports: Required, organic supports recommended
• Fuzzy Skin: I used a fine fuzzy in places with 0.4mm spacing & 0.3mm strength

I would be very happy about a photo of your prints in the comments - check out my other files in the profile :)