Lithophane Lamp 4 photos
Print Profile(1)
Description
I made a lamp with lamp sockets and a wall switch to be embedded inside. Parts must be glued, and the columns can be printed lying down, but this will not completely eliminate the need for supports (This needs to be tested)
The lithophane measurement settings I used were these, but I might increase the total size by perhaps 1mm and keep the border size. I only made adjustments to the height. However, in the slicer, it is possible to take measurements and check the best image size and clearances that you deem best for your project.
See and print my other models! All original and easy to print.
Boost Me (for free)
Fuel my next project! Send a Boost if you like this print. 🚀
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)