Search models, users, collections, and posts
Door Stop Wall Protector 2in1
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
35 min
1 plate
Open in Bambu Studio
Boost
29
71
6
2
93
49
Released
Description
This handy door stop not only holds your door open for you it also protects your wall from you door handle crashing in to it.
simply print and warm the stop flat with a gentle heat gun or hair dryer then bend it to approx 30 degrees
fix in place with double sided sticky tape or glue depending how durable you need it (not advised to glue to carpet)
to release the door just press down on the stop flap with your foot or finger
to fit doors 35mm thick
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)