[Dummy] Aimpoint MAG-1 + Unity FTC 30mm mount

This project is mostly for my enjoyment, any feedback is greatly appreciated, especially with the print configuration since I mostly created the model and commissioned someone else to print it, I have 0 other 3D printing knowledge.

-------------------------------------------------------------------------

This project is mostly for my enjoyment, any feedback is greatly appreciated, especially with the print configuration since I mostly created the model and commissioned someone else to print it, I have 0 other 3D printing knowledge.

A dummy model meant for decoration on model guns. Can be flipped up or down. 

Hardware needed:

• An M4x30mm screw to attach the 30mm mount to a picatinny rail.
• An M4x35mm screw to attach the two halves of the 30mm mount. It might be easier if you use 2 shorter M4 screws and screw in from both sides - I used 2 M4x16mm screws. 
• If needed: Something to add friction like a small strip of tape, as you'll simply insert the Aimpoint magnifier into the 30mm mount.

Be VERY careful when you assemble this mount. The parts and screws are meant to be fitted very tightly.

-------------------------------------------------------------------------

I have a list of prints, mostly dummy optics/optic risers/optic mounts, that I can't really afford to print. If you're interested in testing the prints and sending me showcase photos then feel free to contact me, all files will be free of charge:

• Trijicon MRO + Trijicon 3X Magnifier
• Aimpoint magnifiers with LaRue flip to side mount
• Aimpoint T2 red dot sight v2 (with lens caps that can be removed/rotated)
• ANVL UKON RMR mount for RMR pattern red dot sights
• Unity Tactical RAXIS for B.E Meyers MAWL laser
• Arisaka Low/2.26" Magnifier Mounts 
• Geissele 30mm scope mount
• ACR stock for A&K/DS/STS/AKA/JM gel blasters