Mini Mandalorian N-1 (Naboo) Starfighter

This is the Mandalorian's N-1 Starfighter, complete with movable cockpit pieces
The model is only 25 grams, and highly detailed for a small model.
This is the way for any fans of The Mandalorian to use their filament

*NOTE* If printing the original version make sure to clean the build plate to assure proper bed adhesion.

To assemble:

Grogu's cockpit/bubble canopy simply align the rings on the ship and on the circular cockpit piece and slide the rod through.
Mando's cockpit can simply be slid into place

To assemble the multi-piece model start by slotting the cubeish  block into the top half of the  ship:

Then push the bottom half of the ship onto the cube (make sure the engine is facing the right way)

Next push the tail onto the ship, pushing it into the slot on the main body

Put the wings on.                                                                                                             

Push the engines in                                                                                                                  
Slide Mando's cockpit into place                       

Push Grogu's cockpit into place, sliding the rod through the rings.       

If you're having trouble reading these instructions on a mobile device, I included the pictures below under “Assembly Guide”

The need for supports in the original version causes the underside of the engines and tail to come out slightly rough, if you want to avoid this, print the multi-piece version.

I am working on additional custom supports for the original version, however the multi-piece version is simple to assemble and looks the same.