figma Hand and Face Parts Stackable Box

Dear Figma enthusiasts, when you display your figures, do you put the face and hand parts back in their boxes? When you need to change them, do you find it too troublesome to dig for parts in the boxes?

Here is a stackable hand and face parts storage box for everyone.

Each box consists of four parts: the body, the lid, the face parts tray, and the hand parts tray.

The face parts tray offers four versions, distinguished by the slot width on the back of the replacement face plates, including 2&3mm, 3.5mm, 4mm, and a blank version. Just pick one to print. If your face plate width is not listed, you can print the blank layer and use Blu-Tack to secure it.

The hand parts tray has 10 holes. Through testing, directly printing round pegs for hand parts makes them prone to breaking, so it was changed to holes where you can insert filament and trim it. The back can be smoothed with glue or a soldering iron.

The ends of the three pull-out trays are designed with self-locking buckles, so there's no need to worry about them sliding out after installation.

The box body is designed with grooves on the top and bottom, allowing multiple boxes to be stacked.

The uploaded lid is a blank version, which can be customized by adding embossed text.

If you like it, please give it a like, thank you very much. It would be even better if you could boost it.