Milwaukee M18 Fuel Tool Mount / Holder
Print Profile(1)
Description
Tool mount will work with most tool types. Currently mounted with Tool attached sideways. Printed in PLA Plus + eSun Fire engine red.
Currently been in the back of a work van doing 140 miles on average a day, motorway, back roads and off road and holding up great.
There are other highly rated versions but the fit wasn't right and too loose where the tool would jump out over a rough bump. This fixes that issue, nice and snug!
https://amzn.eu/d/2h17RkQ
I've printed these out of PLA and Pro PLA with no issues with strength but might want to use PETG or ABS if you want to use these in something like a work truck or other environment that might get really hot in warm weather.
Printed in 0.2mm strength profile and no issues.
6 walls
25% grid infill.
Feel free to play with settings to preference if this is not going in a rough environment. Print standing up.
Screw hole depths are : 4mm x 22.7mm and 4 x 7mm
4mm Screws advised . Length advised is 30 mm and 15 mm but longer the better where you can :)
Any questions please through them below and looking forward to your prints.
Will update as suggestions come in.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)