Set Square and Ruler Set (Dual-color printing with only one color change)

Added on 2026-1-27, profiles for 15cm and 10cm rulers

1. Two-color printing distinguishes the scale from the body for more intuitive readings

2. Chamfered and rounded edges, smooth to the touch, no scratching

3. No filament waste, only 5 pieces of waste, only 1 color change, the complete set of four triangles uses only 50g of material and can be printed in less than two hours

4. No layer lines on the surface, smooth on both sides

5. Model accuracy is not an issue, actual accuracy depends on your material's sinkage rate, fully meets daily drawing and measurement needs, easily replaces store-bought models

6. Before printing, clean the build plate thoroughly, dry the filament to avoid warping, stringing, and affecting the model's appearance

7. After printing, wait for the model to cool completely before removing it to prevent deformation

The stationery box for this set of triangles has been uploaded, perfect for storage Link address: https://makerworld.com.cn/en/models/2054129-cheng-feng-po-lang-zhu-ti-dai-qia-kou-yi-ti-da-yin#profileId-2294378

1. Two-color printing distinguishes the scale from the body for more intuitive readings

2. Chamfered and rounded edges, smooth to the touch, no scratching

3. No filament waste, only 5 pieces of waste, only 1 color change, the complete set of four triangles uses only 50g of material and can be printed in less than two hours

4. No layer lines on the surface, smooth on both sides

5. Actual measurement accuracy exceeds 0.5mm, fully meets daily drawing and measurement needs, easily replaces store-bought models

6. Before printing, clean the build plate thoroughly, dry the filament to avoid warping, stringing, and affecting the model's appearance

7. After printing, wait for the model to cool completely before removing it to prevent deformation