0.28mm, 2 walls, 15% infill

My robot vacuum's arch-nemesis has finally been defeated: the 1cm kitchen threshold! 😅

I got so tired of watching it go into full "Kamikaze Mode" and flipping over on that little ledge. So, I designed this "Anti-Kamikaze Ramp" to fix the problem once and for all.

The best part? The design is ultra-optimized and uses ONLY 10g of filament! 🤯 A super quick print that saved my sanity (and its bumper).

The part has a 15cm width and 11mm height, you can print as many as needed to fit your door.

Useful tips:

1. Measure! Take a ruler and check the exact height your bot is strugling with… scale the model on Y axis as needed.
2. Print one sigle piece and do a test… check if it fits well and then print the others!
3. Use a 3M VHB tape or any strong double-sided mounting tape to secure the ramp to the floor.

Your robot’s bumper will thank you!