Tilt n Talk (A Fan Game)

I wanted a 3D printable version of “Tilt and Shout” to give to my english and Special Ed teachers. 

Tilt ‘n’ Shout is basically a high-speed, verbal tug-of-war.

1. The Setup: Place the metal ball (or marble) in the center of the seesaw.
2. The Goal: Get the ball into your "Goal Zone" to win the round.
3. The Play: Flip a category card (e.g., "Pizza Toppings"). Shout an answer and tilt the board toward yourself.
4. The Chase: The ball starts rolling toward you. Your Opponent will have to shout a new answer and tilt it back before the ball reaches your side.
5. The Win: If you’re opponent is too slow and the ball hits your zone, you win the round!

Assembley:

• Print all parts
• The decals can be glued into the zone areas
• In order for the marble to not fall out, the top portion must be glued onto the tilt board. There is a hole In one fun so that the marble can fit through. I recomend using a small pen/sharpie to put an arrow where the starting hole is.

The marble that I am using is an 8mm Ball Bearing

I have also included categories of cards which I cut out and laminated. These were created with Dextros.

ALL RIGHTS to Big Potato Games. This is not my idea.

Basket is a modified design by Eternity Labs to fit the board.