Book Nook & Table, stick-type coffee dispenser

This is an idea that can be used as a practical design in everyday life, and is designed and designed by the Sticky Coffee Mix Dispenser (self-made product name: Cafe 45 degrees). With its geometric design, it goes well Book Nook or with the kitchen and living room or anywhere like a prop, and can also be used as a book nook design. I share it for personal use.

The concept was designed in consideration of the critical angle of FDM in the 3D printer, so it was designed at an angle of 45 degrees, and it started because it seemed that it could be composed of the architectural beauty of the place, and the internal design was designed to naturally bring down the coffee mix with gravity sliding. If stick coffee doesn't come out well due to irregular shapes, tap it lightly, and when you add stick coffee, it comes out naturally.

The shape of the chimney on the roof can be used as a handle to open the lid.

I named the cafe 45 degree "Cafe 45°" because it reminded me of the temperature I can drink comfortably while talking in the hot water purifier water and the hot water temperature we feel in the public bath. Of course, the critical angle of the 3D printer also has a big impact. ^^

Made with Bambrap P2S combo and printed in Bambrap PLA matte (matt) terracotta color. It sits on one bad and can be used without any assembly. Brown, yellow and orange PLA color output is recommended.

The output profile has been corrected for contraction tolerance based on Bambram Pilamint PLA, and it was output using Bambrap matte PLA material.

At the output, a single output produced satisfactory results without shrinkage or spaghetti. If you're satisfied with 0.2 layers, but you want a more precise output, 0.16 layers makes the output better (which will take more time, of course ^^;)

https://makerworld.com/ko/models/2312231-small-stick-type-coffee-mix-dispenser#profileId-2524349