Gengar 3D Printed Pokemon
Print Profile(1)
Description
This is a flat layered 3D-printed Gengar wall or desk decoration. It works best as desk decor, shelf display, kids room decoration, or a collectible display piece. Lightweight and colorful, it’s ideal for adding a fun accent to a gaming setup, office desk, or bedroom shelf.
The great part about these models is they only take a couple hours and use less than 100g of total filament.
Each layer is its own color so there are only five color changes. When changing the colors if you do not have an AMS you can pause the print when each color is finished and change the color.
It is 4.08mm thick and roughly 9" in height.
-Initial layer height is .24 and layer heights are .08.
-I use a height range modifier from .24-4.08 at .24 with 15% infill, 3 bottom shell layers and 5 top shell layers.
-After 4.08 print it at .08 layer heights.
I print with my aux fan off. If you do not I suggest adding a brim.
For more Pokemon and other gaming prints check out my profile.
You do not have to use the exact colors below but it will look better if you do.
Swap Instructions:
Start with Black
At layer #51 (4.24mm) swap to Bambu Dark Blue
At layer #52 (4.32mm) swap to Bambu Indigo Purple
At layer #54 (4.48mm) swap to Bambu Lilac Purple
At layer #56 (4.64mm) swap to Bambu Hot Pink
At layer #60 (4.96mm) swap to Polymaker Cold White for the rest.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)