Silencer .177 / .25 cal 1/2" UNF
Print Profile(1)
Description
Silencer with turbulencer and baffles for .177 &.25 air guns.
1/2" UNF thread inset for adjusting the silencer orientation.
"Thread-99.stl" and "Thread-98.stl" is 1% / 2 % smaller in diameter for better fitting. You only need one.
.25 cal Version added but not tested if material is strong enough. So be careful when testing!
Vertical printing orientation with front side down on the bed
Remark:
To achieve even better damping, I drilled holes in the lower part and pressed foam into the chambers. The holes were then sealed with hot glue (see picture of the bottom part).
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)