Small stick-type coffee mix dispenser

It's a small stick-type coffee mix dispenser

This time, the previous version designed a small stick-type coffee mix dispenser product following the mixed coffee stick-type coffee mix dispenser and registered it in Bambrab Maker World.

It is an idea that can be used as a practical design in everyday life, and is designed and designed by a stick-type coffee mix dispenser (self-made product name: Cafe 45 degrees). With its geometric design, it fits like a prop in the kitchen and living room, and shares it for anyone to use it personally.

The concept was designed in consideration of the critical angle of FDM in the 3D printer, so it was designed at an angle of 45 degrees, and it started because it seemed that it could be composed of the architectural beauty of the place, and the internal design was designed to naturally bring down the coffee mix with gravity sliding. If stick coffee doesn't come out well due to irregular shapes, tap it lightly, and when you add stick coffee, it comes out naturally.

The shape of the chimney on the roof can be used as a handle to open the lid.

Made with Bambrap P2S combo and printed in Bambrap PLA mat (matt) terracotta color. It sits on one bad and can be used without any assembly. Brown, yellow, and orange PLA color outputs are recommended.

The output profile has been corrected for contraction tolerance based on Bambram Pilamint PLA, and it was output using Bambrap matte PLA material.

At the output, a single output produced satisfactory results without shrinkage or spaghetti. If you're satisfied with 0.2 layers, but you want a more precise output, 0.16 layers makes the output better (which will take more time, of course ^^;)

For large stick coffee mix dispenser products, click the Maker World link below.
https://makerworld.com/ko/models/2286834-stick-type-coffee-dispenser#profileId-2494649
 

However, we allow for personal outputs that are not for commercial purposes. I hope you enjoy your 3D output activities.