Good 2 Grow Cap Holder
Print Profile(2)
Description
This quick little holder will help get those good to grow bottle tops out of the way in your cabinets. Less than 50g of filament each they fit perfectly under a shelf in a 12" deep upper cabinet. 2 plates so there is one for a right and left side of the cabinet for easy removal of the juice bottle tops.
Notes:
- There are some supports under the clips. it is not important to remove the whole support as it does not interfere with anything. just need to give a little press to break them free and the print is good to go. (see picture)
- Doublesided tape was used to mount to the underside of the shelf. There are pockets underneath for a 12mm wide by .7mm thick doublesided tape. Supports for this area remove quite nice. If not using the tape, the supports could stay in and use 3M type strips or other means to instal.
This is my first design and first upload so any feedback is welcome!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (17)