Iphone 13 Stand with case and optimized Magsafe

I originally downloaded this model from MakerWorld, but I consistently had problems finding a suitable MagSafe charging cable type that reliably fit the model

Many common solutions only work with special MagSafe cables or variants with an additional USB-C adapter. Precisely these versions do not fit, as they are too long or geometrically unsuitable

🔧 Model Adjustment

I have therefore adjusted the model so that it is compatible with common standard MagSafe charging cables, such as those that can be purchased directly from Amazon

Important:

• ✔ The MagSafe pad must be directly and firmly connected to the cable
• ❌ No additional USB-C connector between the cable and the pad
  → otherwise, due to the design, it will not fit into the model

⚠️ Note on the Inner Bridge

For technical reasons, I could not remove a small bridge inside the model.
When attempting to constructively remove this bridge, the 3D model became unstable or geometrically damaged

Solution:

• After printing, I simply cut off the bridge with filament cutters or side cutters
• This works without problems and affects neither stability nor function

✅ Conclusion

After these adjustments, the model works reliably with standard MagSafe cables, is stably printed, and is easily usable in everyday life.
From my point of view, the small manual post-processing step is the best compromise between printability and function