Search models, users, collections, and posts
Millennium Ring Necklace
Remixed by
IP Report
Print Profile(4)
A1 Mini Plate
Designer
2.1 h
1 plate
LARGE Ring single color
Designer
3.4 h
4 plates
Multicolor Plate
Designer
3.3 h
1 plate
Needles Separate
Designer
27 min
1 plate
Open in Bambu Studio
Boost
285
586
40
23
642
324
Released
Description
Millennium Ring Pendant Necklace
I remixed the original from a user on thinigiverse i have linked.
My Remix is of the piece split in half and uses dowels / Glue to Snap together, this ensures a smooth surface on both sides, i previously printed as is from the original and found the backside to always be rough due to needing supports so this is a way to get rid of supports and have a clean finish on both sides.
I also went ahead and adjusted the ‘’ Spikes " Remodeled these from scratch to be thicker and not as prone to breaking.
Printed in PLA .14 / 4 walls / 35% infill but you are free to play with your settings as needed.
.3mf file will have preset settings you can print from and is scaleable as well. :)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (40)