Ashin Projection Lamp

26.3.16 Final Version Update Notes: Updated configuration: Ashin Projector Lamp No Wiring Version

Since wiring was cumbersome, the light source has been changed, wiring has been removed, and the original magnetic suction is replaced by strong magnets. Accessories are as follows

Glue: The light source bracket needs to be glued together

Strong magnets (strong magnets marked on PDD are not very good, not recommended): Round Small Strong Magnet High Strength Neodymium Iron Boron Magnet Permanent Magnet Rubidium Magnet Iron Suction Magnetic Sheet Buckle - Taobao (recommended link), buy 15*2 diameter ones, each projector lamp requires two pieces

Light source: 1W Ultra-bright LED Bulb 6V Lamp Bead Battery Lamp Light Source Lantern Creative Handmade DIY Mini Night Light with Switch - Taobao White light

Diagram after installing the latest version

The bracket is divided into two parts, requires gluing, each of the bracket and base has a magnet installed, Note the polarity of the magnets!

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

By modifying the outer wall pattern of the Bobo pot to achieve the effect of projecting Ashin's shadow with a single light source

Currently, the light source is connected via a magnetic connector, it can be directly removed and used as a Bobo pot, serving two purposes. The connection between the Bobo pot and the base requires four pairs of 5×2 diameter magnets

Mainly, purchase a single LED bead kit and change the wiring of the single LED bead to a magnetic connector connection

Single LED bead kit link: Single LED Bead Charging Touch Desk Lamp Accessories Touch Sensor Dimming Lithium Battery Charging Board Lamp Kit - Taobao Purchase: Complete set (square battery + single LED bead white light)

The magnetic connector uses 8mm, link: Manufacturer New 3A Round Waterproof Magnetic Wiring Connector Magnetic Adsorption Magnetic Head Magnetic Connector - Taobao Purchase: DC-906-8mm with XH terminal White [male and female pair]

Bobo needs 5 colors, currently, two versions have been made

(1) Dual AMS version, can be printed directly

(2) Single AMS version, a pause has been added during printing, just replace the green filament with blue filament after the pause

Wiring is as follows

If a single magnetically controlled LED bead with sufficient brightness is found later, another version without wiring can be released. If not found, then this will suffice for now

There is also a version that can add a sound module, with a switch to play fixed audio, but due to complicated wiring, it has not been released. If needed, you can ask me for it separately

26.2.5 Update

The model has been slightly scaled down, and two printable configuration versions for the A1 mini have been added

26.2.9 Update

Many people don't quite understand how to wire, so a tutorial has been roughly made

The model is for material exchange only, group buying and commercial activities are strictly prohibited!!!