Print Profile(1)
Description
This model consists of two separate stands (DX and RX) designed to support laptops, tablets, or similar devices at an inclination angle of approximately 15°, improving ergonomics and airflow.
The design is minimal and slanted, with no moving parts, focused on stability, simplicity, and a clean desk setup.
Important Printing Notes
This model is prone to warping, therefore several precautions have already been included:
• Integrated mouse ears on each stand
• One model per build plate is strongly recommended
• Reduced print speed during the first part of the print to improve initial adhesion
Printing Recommendations
To further minimize warping, I recommend:
• Washing the build plate with dish soap and warm water
• Drying it thoroughly before printing
• Using standard bed adhesion settings in your slicer
With these precautions, the print worked reliably in my case.
If you print this model and find it useful, a boost would be greatly appreciated.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)