Phone Holder - Table Holder - Phone Stand

There are already many holders or phone stands for mobile phones, but I never found the right one for me …

I didn't want to constantly hold the phone in my hand, but it should also stand securely and be normally operable, and you should be able to charge it in the holder.

This holder then resulted.

The holder can be adapted to almost all common smartphones with the small plates.

Sometimes you need 2 small plates or one is sufficient, no matter if you have an iPhone, a Samsung, a Xiaomi or another mobile phone - the holder can be individually adjusted with the small plates

The holder has a size of approximately 100x90x40mm.

It can happen that the model still warps during printing. This is due to the auxiliary fan, so the holder should be printed further away from the fan on the build plate.

Disclaimer:
* - some external links contain affiliate data. If you order something through these links, I will receive a small commission to supplement my pension, it will cost you nothing extra.

Thank you very much.

Please note: The quality of the print has a lot to do with very well-dried filament and a very clean print plate. Please check your printing environment and adjust the print bed and nozzle temperature to your filament.
The models shown here are without exception printed with Bambu Lab P1S.

*Filament dryer: https://www.kleinanzeigen.de/s-anzeige/3-fach-filamenttrockner-doerrautomat-neu/3450232254-249-20831

*Container for storing filament spools: https://amzn.to/4eyK6sQ - the filament spools fit in there perfectly

*Silica - granules - https://amzn.to/4fxnWbx - I take 40g per container (4L), if the granules have become dark due to humidity, they are dried in the oven at approx. 70 degrees, they turn orange again and can be reused

*Bambu Lab P1S 3D Printer: https://eu.store.bambulab.com/products/p1s?from=navigation