B&BW Foam Soap Holder - Interchangeable Plates V2

This is V2 of my previous model.  V1 can be found here 

The base model with no cutouts can be found here

UPDATED FROM V1

• Shorter clip instead of full length. 

I designed this base for bath and body works foaming soap holders. 

• This design allows you to add your own custom plate in a simple way without complex experience with CAD.  Simply add a design to the insert piece and slide it into the holder box! 
• If you don't want to add the insert to your design you wish to have on the holder, you can also print the insert separately and just glue it on! 
• I also added a hole in the bottom to allow any water or soap to leak out instead of building up. 

I hope you enjoy this design and happy printing! 

I keep all my models free for personal use, if you wish to support me you can buy me a coffee! buymeacoffee.com/honeybunny3d

If you would like to sell my models please check out my patreon! https://www.patreon.com/cw/HoneyBunny3D

Extra Info

• I made sure there was enough space between the clip and the base so when you attach your designed plate you don't have to worry as much about the depth position when attaching clip. 

• The length from the bottom to the clip is 115mm, remember that when positioning your clip onto your desired plate so the bottom isnt too far that it doesn't fit. 

I keep all my models free for personal use, if you wish to support me you can buy me a coffee! buymeacoffee.com/honeybunny3d

If you would like to sell my models please check out my 

makerworld commercial license or my patreon! https://www.patreon.com/cw/HoneyBunny3D