Search models, users, collections, and posts
Meat injector case
Remixed by
Print Profile(2)
0.2mm layer, 4 walls, 15% infill
Designer
5 h
2 plates
0.2mm layer, 4 walls, 15% infill
5.3 h
2 plates
Open in Bambu Studio
Boost
4
26
5
2
33
26
Released
Description
This is a remake with a nicer cover , of the nice model from Bpopp on Thingiverse (https://www.thingiverse.com/thing:2671239)
This is a nice case for an inexpensive stainless meat injector that can be found at your favorite online retailer. It was designed specifically for mine but I suspect it will work with many similar models. The main body of the injector should be around 32mm in diameter, the 2 large needles are 5mm, and the smaller is 3mm.
The cover includes a nice injector logo.
Post-Printing
I used two 22mm M3 screws in the hinges to join the top and bottom. No tapping should be required, but go slow so you don't split either hinge.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)