Print Profile(1)
Bill of Materials
Description
My daughter is currently in absolute Harry Potter fever. She reads a lot and wanted a reading lamp for her bed.
Since I still had an LED Kit001 lying in my drawer, I quickly designed and printed a suitable reading lamp for her.
The result brought a smile to her face. 😊
Perhaps someone else will like the lamp too.
Assembly:
The LED Kit001 is simply inserted into the LED retaining ring and then clicked into the lamp head (Sorting Hat).
The cable is inserted into the holding arm with cable guide.
Then both holding arms are screwed at the top with the lamp head and at the bottom with the retaining clamp.
The thumbscrew is inserted into the retaining clamp and screwed in until it is visible on the other side. Then the cap is screwed on.
Note:
Before final assembly, it is recommended to screw all screws into the threads once as a test.
This worked perfectly for me.
Tip:
If a screw is a bit difficult to turn, simply turn it a small piece forward and back again until the thread is cleanly cut.
The retaining clamp is designed for a maximum board thickness of 15mm.
Boost Me (for free)
If you like this model, I would appreciate a boost to support my work. Thank you! 🙏
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)