Print Profile(1)
Description
Made these legs to replace the 10.4" deep legs on my new Roku 55" TV. I have a mantle that's only 10" deep so I needed something a little shallower. I made these legs to be 9" deep, slightly shallower in the rear since it is against a wall there. And, as always, I avoided any unnecessary supports. The holes for the screws do turn a little oval, but there's enough clearance that it's not a problem at all.
With the legs printing on their side as shown in my print profile, you shouldn't need high infill as the layer lines will stretch and accommodate the weight of the TV itself. However, if you're feeling a little uneasy, I'm sure a couple more wall loops wouldn't hurt anything.
Please verify that the dimensions of the slot on the bottom of the TV matches yours by checking the dimensioned sketch in the photos. The dimensions there are in millimeters.
Since the front leg is longer than the back leg, the two sides are not interchangeable and you will need one left and one right.
If you need any modifications, please let me know and I'll do my best to make them happen for you!
Boost Me (for free)
Help me keep my models free by boosting!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (5)