Cat Kong (Treat dispensing toy)
Print Profile(1)
Description
I wanted a simple cat treat toy that required no gluing or joints. So I came up with the cat Kong this interactive rolling treat toy will stimulate your cats mind and keep them entertained for hours! This print comes in two parts the main toy and the cap. Both can be printed on a single plate in about 45 minutes.
In order to make this without requiring glue or joints and to keep the rounded bottom for extra wobble this print requires some pretty annoying supports. these supports will be “trapped” inside of the main body after printing. They should be easy to pop off but will need to be broken apart to pull out of the body. To do this I just used a small screwdriver through the treat hole on the side and broke apart the supports into smaller pieces. I then just pulled them all out with needle nose pliers! I will work on a minimal support model soon to make this easier to deal with!
All feedback and pictures would be appreciated in the comments! Thanks for stopping by and checking out my work!
Boost Me (for free)
All boosts are greatly appreciated and help me to make more great models!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)