Search models, users, collections, and posts
Chitu Systems PlateCycler C1M
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 8 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
16
45
4
3
56
30
Released
Description
Content has been automatically translated.
If you have purchased the chitu systems platecycler and sometimes it does not eject the plates correctly, the problem is warped plates. With this ramp, you permanently solve the problem, provided that you also install the swapmod guides under the Y-axis as indicated below
I took the swapmod ramp as a starting point and adapted it to the chitu systems platecycler by adding specific interlocks under the ramp
Press with your thumbs where indicated by the arrows to snap the piece into place
WARNING:
Strongly recommended to install this component to assist in pushing the plate
https://makerworld.com/it/models/1093569-swapmod-plate-pusher-prevents-jam-safely#profileId-1087513
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)