Search models, users, collections, and posts
Xiaomi Mi Monitor Light Bar Controller Backplate
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 12% infill
26 min
1 plate
Open in Bambu Studio
Boost
99
260
42
21
348
280
Released
Description
I wanted to mount my Xiaomi Mi Light Bar controller under my table, but unfortunately, there was no screw holes in the original base.
If you have issues with the base rotating, some friction material or tape might help.
You need to print:
- 1pcs Base
- 3pcs Clips
Printed with .4 nozzle at .2 layer height in PETG. However, even PLA should be sufficient and might require less cleaning.
The clips should be printed laying down, so that they are stronger. After printing, the clips can be glued to the holes in the base or just pushed in. If you are using the screw mount, the clips are held in by the surface, to which the base is attached to.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (42)