Search models, users, collections, and posts
Large poop bin
IP Report
Print Profile(1)
0.2mm layer, 1 wall, 0% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
2
6
0
0
7
3
Released
Description
Content has been automatically translated.
Using less than 100g of filament, printing in less than 3 hours (requires adjusting the minimum filament printing speed), you will get a large poop bin with a bottom diameter of about 18cm, a top diameter of about 25cm, and a height of about 23cm. PETG print has been used for over a month, strength is not an issue (PLA not tested)
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)