Search models, users, collections, and posts
Dragon bust with outstretched wings
IP Report
This model is created by Image to 3D
Make Your Model
Print Profile(1)
0.08mm layer, 4 walls, 10% infill
Designer
11 h
1 plate
Open in Bambu Studio
Boost
1
3
0
0
0
0
Released
Description
Large dragon bust with outstretched wings.
Large Dragon bust with outstretched wings, open mouth. Print the supports with large brims as they may tip over otherwise. I printed this in black Bambu PLA, and it turned out very good. I plan on doing a rub and buff finish and may upload more photos of it when completed. Supports are bit stubborn so make sure you use a good needle nose plyers when removing them, so the teeth and wing tips do no break off.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)