Super Fast Spool Winder Only 20g

This is a fast to print Filament winder. Prints in less than 1 hour and uses 20 grams of filament.

You'll need a M5 threaded bar and 1 x M5 nut.

First, mount the nut in the bar, and then, add one side of the winder. Tighten the nug against the winder to lock it in place, so it won't spin when you have the driller running.

Mount the spool and add the other side of the winder. Insert your fingers in the holes to tighten the other side of the winder against the spool. Make sure to have it tight, but do not exaggerate.

You can print it in Sport, for a 45 mins print.

If you still have doubts, just check the images.