Search models, users, collections, and posts
QIDI MAX 4 VENTED RISER BY SAC3D
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
19.3 h
4 plates
Open in Bambu Studio
Boost
18
37
3
0
101
10
Released
Description
QIDI MAX 4 VENTED RISER BY SAC3D
For Non Vented Version Please See, https://makerworld.com/en/models/2581184-qidi-max-4-non-vented-riser-by-sac3d#profileId-2846840
Vented Riser for Qidi Max 4. Tested in PLA and PETG. Allows the glass to slide as intended. Test printed in both PLA and PETG. Printed 0.2mm layers, 15% infill, no supports. i did print with a brim on the sides to help prevent warping, this may not be needed. 2 versions, one clean with no extra cut out for the USB and one other that has a cutout for a USB stick to clear. please let me know if the tab fitment between parts it too tight of too loose. Fitment tested in both PLA and PETG so should be good to go.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)