Simagic Haptic (HPR) mount for Heusinkveld Sprint
Print Profile(1)
Bill of Materials
- Simagic HPR x 1:
Description
Additional parts needed: 4 M3x12mm screws (a little bit shorter or longer should also work)
Print the mount and 2x each washer. Use 4 perimeters and 25% infill.
Then mount the reactor the mount first with the included M4 screws. After that you can mount it to the pedal by using the M3 screws and the washer. The M3 screws will thread into the plastic holes.
Use the smaller washer for the top hole and the bigger washer for the bottom hole. Don't overtighten, but tighten until the play is gone.
This mount is for the brake only.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)