Flower Hairpins

Introducing these beautiful Flower Hair accessories where fashion blooms through your creativity

At less than 15 gram, these Flowers only needed minimal filament and time to print out

This Hair Accessory comes in 2 possible configurations (Each with a Single color and Multi Color Configuration) guaranteeing something for everyone.

1. A  Flower meant to be used with a simple/cheap bobby pin
2. A Flower with a hair stick allowing for a 3 color combo look with a hair stick

Mix and Match colors to find the perfect combo for you, accessories meant for all occasions

Assembly Guide:

1st Configuration

For the Flower meant to be used with the bobby pin, ensure the Inner petal and Outer petal holes are aligned in the correct orientation before pressing each together. Afterwards insert one end of a bobby pin into the hole and viola! 

2nd Configuration

For the Flower meant to be used with the hair stick, press the inner petal into the Outer Petal (No specific orientation) and they should just snap together. (It may be easier with a flat surface and the use of the hair stick to press from the center of the inner petals). For inserting the hair stick, on the outer petal, one of the holes has a small indent and indicator mark (A small E)  to show where to correctly insert. 

Printing Notes + Helpful Tips:

-For the Hair Stick since the contact surface is small, make sure your build plate is cleaned and leveled for the best possible adhesion. 

-Use a knife or flat surface to remove as much brim and supports as possible before inserting it into the flower 

-Since the tolerance of the petals in very fine, the flower petals may not fit together properly depending on individual printer tolerances. If to tight, try slowing down the print speed (especially for A1/A1mini/bed slingers). If a little loose, either scale the inner petal 0.1% larger or use of glue to help secure the two parts