DJI Action 2 GEPRC Vapor Mount
Print Profile(1)
Description
Remix of ScreaminFPV's DJI Action 2 Diamond Mount for the GEPRC Vapor Drones
Link to ScreaminFPV Base model
Please refer to the link above for ScreaminFPV's Diamond Mount features and previews for Camera views & angles w/wo ND Filters
Model Uploaded is 25 Degrees tilt, if needed i can modify by comment/chat request (I used Bambu Lab TPU 90A)
The rear M3 screws are slightly recessed and require a bit of flex in the TPU Pre mount to installation
Because of the tight clearance at the back of the mount, the easiest way to install the back two screws are to Place the screw onto the tip of an Allen driver and then Carefully wedge the screw into position from the Side or Rear
The screw channels pass through the bottom layer of the mount, allowing you to insert an Allen key from above to fully tighten the screws once they are started.
This design keeps the mount rigid and short
This remix is based on
License
You may create derivative works based on this object, provided that all such derivative works are published exclusively on the MakerWorld platform and include proper attribution to the original creator. You may not share, upload, host, distribute, or publish this object—or any derivative work of this object—on any other digital platform, marketplace, or distribution channel. Commercial use of this object and any derivative works is strictly prohibited. This includes, but is not limited to, selling, renting, sublicensing, or using the object in any context in which you receive monetary compensation or other financial benefits.
Comment & Rating (2)