Print Profile(1)
Description
Created using Bilibili UP大胖胖肥猫's open-source softwareLumina-Layers.
Using Bambu Lab official filaments:
- 10100 Jade White
- 10200 Red
- 10400 Yellow
- 10601 Dark Blue
Note:
0.4mm nozzle, manually enable bed leveling, the sinkage rate in filament settings must be the same
When scaling, be careful not to change the Z-axis height. If scaled down, check whether the first 1-5 layers after slicing are too small to print lines; if so, scale up.
It is highly recommended to use a smooth printing plate and apply glue before printing; avoid strong pulling when removing the model to prevent tearing the fine structures of the first layer. If the first layer does not adhere, try rotating the model 180° to print face up, but the pattern quality will be slightly worse
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)