Charmander - Pokemon - HueForge
Print Profile(1)
Description
Happy Pokemon Day 2026! I got inspired with the rerelease of Fire Red.
For this print, I did use a 0.2mm Stainless Steel nozzle. The model is 68.42mm by 100mm in size or slightly bigger then a trading card.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
This print uses 6 unique filaments
Swap Instructions:
Start with Charcoal Black - PLA PolyTerra Charcoal Black Transmission Distance: 0.3 (Any black will probably be fine.)
At layer #11 (0.56mm) swap to Silver - PLA BambuLab Basic Silver Transmission Distance: 1.2
At layer #18 (0.84mm) swap to Scarlet Red - PLA BambuLab Matte Scarlet Red Transmission Distance: 2
At layer #25 (1.12mm) swap to Lemon Yellow - PLA BambuLab Matte Lemon Yellow Transmission Distance: 3.5
At layer #39 (1.68mm) swap to Cold White - PLA Polylite Pro Cold White Transmission Distance: 0.4
At layer #42 (1.8mm) swap to Arctic Teal for the rest - PLA PolyTerra Arctic Teal Transmission Distance: 0.1
When loading more than 4 filaments I would load them as follows:
- Black
- Silver
- Red
- Yellow
Once the print starts, pull #4 Yellow. Once the printer gets to Yellow, you'll see an error message since slot #4 is empty. At this point, load #4 Yellow again, and change to the following.
- Black - change to White
- Silver - change to Teal
- Red - no change
- Yellow
Resume the print and you should be good to go. Any questions give me a shout.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)