Photo and Post Card Stand

This is a petite, functional 4-inch wide stand designed specifically for displaying smaller items like standard photos, postcards, and small unmounted prints. 

It shares the same minimal styling and rounded edges as its larger counterpart, ensuring it doesn't distract from whatever you are displaying. The profile is kept extremely slim and simple, omitting the internal arch of the larger model for a lightning-fast, highly efficient print while still maintaining a great viewing angle.

I designed this petite version following the strong interest in the larger model. If you need to support heavier / larger frames (10 x 12 up to 16 x 20), check out the original 8-inch version here: https://makerworld.com/en/models/2461841-wide-base-photo-and-frame-easel-stand

Print Specs

• Size: ~4" wide.
• Material: Standard PLA works perfectly.
• Filament Usage: Extremely lightweight—takes less than 7g of filament!
• Supports: Very simple supports recommended to support the top bottom edge.
• Color: Choose a filament that complements your photo. Matte finishes tend to look best for display pieces.

Technical Breakdown

• Width: 4" (Provides the perfect footprint for smaller media).
• Angle: The stand is pitched for an optimal viewing angle at 15-or-so degrees, which will vary slightly depending on how the photo or postcard seats.
• Design: Streamlined and minimal.
• Finish: Filleted/rounded edges for a cleaner, unobtrusive look.