Search models, users, collections, and posts
Gweike M3 Hinge Drill Guide
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
3
2
0
0
5
0
Released
Description
I had some issues with the hinges for the lip of my Gweike M3 Ultra. I found that some screw holes were drilled off location at the factory and they needed to be repaired.
Included are a spacer block that acts to space the lid the correct distance for the hinge and acts as a drill guide to use a 19/64" drill to install rivet nuts in place of the threaded holes in the sheet metal. Also included is a flat plate that acts a guide to check hinge screw hole location.
Required Supplies:
- Drill
- 11/64" Drill
- M5 Rivet Nuts
Use Steps:
- Screw Spacer Block to M3 lid
- Align lid to frame side hinge holes.
- Use 11/64" drill to drill new hinge bolt holes
- Unscrew Spacer Block from Lid
- Install M5 rivet nuts
- Install hinge
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)