TrailPocket Socket Holder

A small, compact 3D-printed socket holder designed to securely carry 4mm, 6mm, 8mm, 10mm, 12mm, and 14mm sockets in one organized tool tube. Its lightweight, space-saving design makes it perfect for tool rolls, glove boxes, and trail kits—ideal for off-roading, dirt biking, ATVs, and quick repairs when you're far from the garage. 🛠️🏍️

*Designed only for the use of short ¼ inch drive sockets*

Instructions

1. Grab your 14mm socket and load the 8mm inside of it, finally add the 6mm socket upside down into the 8mm socket 
2. Put first the stack inside the TrailPocket with the 14 at the bottom
3. Grab your 12mm socket and place the 8mm socket inside of it
4. Load the second stack into the TrailPocket
5. Place the final 4mm socket inside of the container on it's side
6. OPTIONAL add some gauze or cotton to prevent rattling
7. Seal the container
8. FInished!

I personally printed in PLA but PETG is recommended for it's higher chemical resistance