Comma C4 Desktop Stand

A quick and easy stand designed to allow you to keep your Comma 4 off your desk while developing or just messing with it. This requires not supports to print on any sufficiently capable printer. Given the purpose of this, printing in PLA should be sufficient - but if you do have an outdoor desk or something maybe go with something UV resistant.

The 3MF has two plates, one with 4 square 13mm wide 1mm deep negatives for use with rubber feet / bumpers to give it grab on desk surfaces. You can resize the negatives or even replace them with cylinders depending on your use case.

Warning

The mount on this stand was designed thinner than the stock mount to allow for easy sliding action. It is held in by gravity. This is meant for desktop use - for development work, or otherwise just to keep it off your messy desk. This is not meant for use in any sort of serious mechanical fashion.

Credit

While not a remix of this, those STLs were used as references and are still in the OnShape document. It would have taken me twice as long with them, thanks DigitalN.

Demonstration

Modifications / Remixes

This was designed in OnShape, the document is public and can be accessed here: https://cad.onshape.com/documents/b22d50ca47a14c7cff3c53fe/w/4fbb5e5e09aa07e71e1bc95d/e/27f3e2ac65a8bc0c79af4fdc?renderMode=0&uiState=69b6f4378f160613f87ed0ea