Interlocking modular mat for shoes, or anything
Print Profile(1)
Description
Boost Me (for free)
If you found this useful, please consider boosting!
This is an interlocking mat, with a modular design, for putting shoes or boots on…. or anything else you might need a protective mat for…
The print profile contains 8 pieces, which makes a mat of approx 98cm by 33cm, but you should be able to use just the end pieces, or with two, six or more middle pieces.
Print plates 1-4 are corners and 5-8 are middle pieces.
The mat is 4mm thick (for durability) and has a 4mm lip around the edge.
Each piece just fits on a P1S printing bed, but I'm sure it can be scaled up or down as needed.
I have superglued mine together and put some sealant on the joints at the back to make water-resistant as my version was printed to go inside a box. You can see the box in the picture. Note that the original version of the mat had some cut-outs in the corners and centre so it would fit in this box, but the uploaded version is just rectangular without any cutouts.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)