Search models, users, collections, and posts
Tolerance Tester 2.0
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
20 min
1 plate
Open in Bambu Studio
Boost
35
77
35
5
447
284
Released
Description
This is the 2nd variation of my tolerance tester.
If you have any suggestions, please comment.
On my Ender 2 Pro i was able to move all of them, just the .05 was a little harder.
Changes:
It now uses less than a quarter of the material the original did.
Prints a lot faster.
The text is more readable.
The cylinders don't fall out.
Boost Me (for free)
Like my models? Boosting always helps out!
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (35)