Harry Potter / Ikea Strala street lamp

I’ve had an IKEA Strala lamp with a paper shade for a few years, and recently I felt like giving it a fresh look. After thinking it over, I decided to rework an existing model that Dom created and adapt it for the Strala. The end result is a sleek, white, Harry‑Potter‑themed street lamp with a translucent shade decorated with symbols from the series. And frankly I love it 😊 

Here are some guidelines on the print and the assembly: 

• For the lamp glasses/shades: I used Bambu PLA Translucent (Mellow yellow) but if you don’t have any, just put the white PLA but reduce the infill to 10-12%. They fit pretty tide, but if you decide you can superglue them. 
• For the direction sings, I used light brown Bambu silk (mine was Dawn Radiance that happen to be on the brown part) but you can use normal brown instead (like matte Caramel). Just make sure that the letters are colored in white to pop-up.
• For the sings clips – they fit very tightly to the Strala pole so I super glue them to the back of the sings. 

And that it. Assemble the height is around 70 cm (27 inch) and fit perfectly in my home. 

IKEA Strala lamp: https://www.ikea.com/gb/en/p/strala-table-lamp-base-white-40333083/

It fits IKEA LED bulb 14 (mine was 400ml)

____________________________________________________________

☕ If you like my designs, you can Buy Me a Coffee  or 

⚡ Check out my stash of coaster designs with holder. 
🔧 For best resuts I also created Ironing Calibration Test .