Search models, users, collections, and posts
Arca-Swiss Plate 50mm
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
2 plates
Open in Bambu Studio
Boost
2
26
0
0
22
6
Released
Description
This is a 50 mm long Arca-Swiss plate.
The photo shows a 1/4-inch, 14 mm long screw installed.
The small C-shaped part is a retainer to prevent the screw from falling out.
After inserting the screw, place this part into the hole and glue it in place.
The TPU sheet can optionally be replaced with a 1 mm thick cork sheet if you prefer.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)