Search models, users, collections, and posts
BirdBuddy Pole&Wall Mount
Print Profile(1)
0.2mm layer, 4 walls, 25% infill
Designer
10.8 h
2 plates
Open in Bambu Studio
Boost
4
15
0
0
12
9
Released
Description
A wall mount and a 13mm pole mount for BirdBuddy. I used zip ties to attach the mount to the pole. You may want to use PETG for improved UV resistance but I imagine PLA will work ok as well.
This does not use the BirdBuddy pole mount, the screws are used directly in four holes of the print. This is for stability as there is a lot of wind in my area. You may want to want to attach BirdBuddy 90 degrees rotated to allow for easy access when filling up with bird food.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)