Quantum Egg Fidget

This Quantum Egg Fidget makes a fun addition to any Easter basket 🪺 It prints in two parts that slide together for a cool visual effect.

0.2mm Layer Height

PLA and PETG work great

10% Infill

Outer Wall Speed 50 mm/s

Inner Wall Speed 100 mm/s

Resolution (under ‘Quality’ tab) 0.005 mm

I have included a 3mf project file with the following print plates:

Print Plate #1 (Quantum Egg_inside): 1 color, resolution (under ‘Quality’ tab) 0.005 mm, Outer wall speed 50mm/s & Inner wall speed 100mm/s

Print Plate #2 (Quantum Egg_outside): 1 color, resolution (under ‘Quality’ tab) 0.005 mm, Outer wall speed 50mm/s & Inner wall speed 100mm/s

Important: Make sure the print bed is clean before printing. This print requires good adhesion. If needed, smear a little glue stick on the print bed before printing (I like to do it while it’s warming up) to ensure good adhesion.

My designs are free for personal and non-commercial use. I offer a commercial license on Thangs. Here is a link if you'd like to check it out 👉 https://thangs.com/designer/3DPmom

If you like my work and want to help support it, you can buy me a Diet Coke at https://www.buymeacoffee.com/3dpmom Thanks so much!