Xbox One Controller - Simple under desk holder

** Update: added a PS4 controller version - i'm printing it as i write here, so hopefully it works :) Also added a v2 of the xbox controller holder - it's slightly thicker, and has a brace on the lower arm for more strength.

wanted a really simple under desk holder (for my Autonomous desk) to hold my Xbox One controller that is connected by Micro USB to my PC. Wanted it wide enough to hold the controller well, but also didn't want this to take hours to print.

On my CR-6SE, this took 2.5 hours, with 0.28 and 10%fill with minimal support needed (i used tree support touching plate only, which generate a small support for the hole needed for the microSD cable). It is also stuck on the bottom of the desk with double stick tape.

I also have a playstation controller that I will modify this for at some point. Right now, this does not hold the playstation controller well (the 2 bumps at the bottom of the sticks interfere with the holder's ability to stabilize the controller) So look out for that make.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.28

Infill:

Filament:SUNLA PLA Grey