Search models, users, collections, and posts
Motorola Advisor TPG2200 Belt Clip
IP Report
GIF
Print Profile(3)
PETG - 0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
PLA - 0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Multicolor-PLA 0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
2
17
0
0
26
13
Released
Description
Motorola Advisor TPG2200 belt clip
Cuttout at the bottom to easily remove the device
Button on the left side to easily press the side button
I used the following belt clips on amazon:
https://www.amazon.de/dp/B07KM21Q3H?ref=ppx_yo2ov_dt_b_fed_asin_title
They fit perfectly and the rivet can be used to pin them.
Just use a hammer and a screwdriver to plug it in, while having a counterpart on the other side.
The button on the side is printed in overhang without supports so you have to should use a knife to cut excess material (see the following picture)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)