Search models, users, collections, and posts
Filament Tube Holder A1
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
1
2
0
0
1
0
Released
Description
Content has been automatically translated.
A simple holder for a maximum of 4 filament tubes for the A1.
The holder fits snugly and does not slip. This applies to both the tubes and the A1 itself. It is possible that the A1 may string when printing the tube holder, making the holes slightly too narrow. This means it may be necessary to adjust the holes a little.
The holes fit a maximum 4mm thick tube.
Two M2 screws with a maximum length of 11.5mm are required.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)